Century homes, meaning houses roughly 100 years old or more, sit on the older streets around downtown Oshawa, downtown Whitby and old Bowmanville. Buyers love the brick, the high ceilings, the wood trim and the deep lots. They also tend to ask the same question when they call: why does a century home inspection sometimes cost a bit more, and take longer, than an inspection on a newer house of the same size? The short answer is that a 100-year-old house has been built, rebuilt and updated in layers, and every layer has to be looked at. This post walks through the factors that change the price and the time on site, so you know what you’re paying for. Your inspector is Yama Nehan, a Certified and Registered Home Inspector with about 15 years of home inspection experience and a construction engineering degree from George Brown (Building Renovations). He is also a licensed contractor with about 20 years of construction experience and the owner of Nehan Construction, and that practical construction experience is one of the main reasons clients pick him. He has opened up enough old walls to know what tends to hide behind them. Yama Nehan is the only one trusted to do the inspections himself. Home inspections start from $499; the final price depends on the property. Call 647-704-7100 or book an inspection online.
Key takeaways
- Home inspections start from $499. For a century home, the final price depends mostly on size, layout, access and how many systems the house has.
- Older houses take longer because there are more generations of wiring, plumbing, heating and framing to trace and describe.
- Basement apartments, detached garages, coach houses and crawlspaces all add time on site.
- Hazard testing (asbestos, vermiculite, mould, radon) is separate from the visual inspection and is quoted on its own.
- Ask for a firm quote before booking: give the address, square footage, number of units and anything unusual about the property.
- Inspection-first: Golden Home Inspections reports on condition and does not use the inspection to sell repairs.
Why a century home inspection is different
A house built in the 1950s usually has one original set of systems and one or two rounds of updates. A house built before the 1920s may have started with a coal or wood furnace, gravity hot-air ducts or a boiler, knob-and-tube wiring, galvanized or lead water lines and a stone or rubble foundation. Over a century, owners added electrical circuits, swapped heating systems, rebuilt kitchens and bathrooms, finished basements and sometimes added a rear addition on a different foundation. A good century home inspection doesn’t just list what’s there today. It explains which parts are original, which have been updated, and where old and new meet, because that’s where most problems show up. For local detail, see home inspection in Oshawa, home inspector in Whitby and our guide to older home inspections.
The cost factors, one by one
| Factor | How it affects price and time | What buyers should expect |
|---|---|---|
| Size and finished area | More rooms, floors and finished space take longer to walk, test and photograph. | Have the square footage, including the finished basement and attic rooms, ready when you ask for a quote. |
| Number of units or suites | A basement apartment or upper unit has its own kitchen, bath, exits and often its own electrical and heating to check. | Mention any second unit up front. It’s one of the biggest changes to the time on site. |
| Foundation type and basement access | Stone, rubble or brick foundations need a closer look at mortar, moisture and past repairs. Low headroom and storage slow things down. | Ask the seller to clear walls and corners in the basement before the inspection. |
| Layers of electrical work | Tracing old circuits alongside new ones, and checking the panel for mixed wiring, takes extra time. | The report notes any knob-and-tube that’s visible and where a licensed electrician should take a closer look. |
| Heating system history | Boilers with radiators, converted systems and signs of an old oil tank all add checks. | Ask the seller for service records and whether an oil tank was ever used or removed. |
| Additions and renovations | Each addition is another roof joint, foundation joint and set of connections to check. | Ask what was added or renovated, when, and whether permits were pulled. |
| Attic, crawlspace and roof access | Small hatches, knee-wall attics and crawlspaces under additions take time to reach safely. | If a space can’t be safely reached, the report says so. Clear hatches ahead of time. |
| Outbuildings | A detached garage, coach house or workshop is an extra structure to inspect. | Say if you want outbuildings included when you book. |
| Hazard testing add-ons | Asbestos, vermiculite, mould or radon testing is separate from the visual inspection. | Quoted separately; see home hazard testing. |
Factor 1: Size, layout and finished space
Century homes in Oshawa, Whitby and Bowmanville range from modest one-and-a-half-storey workers’ cottages to large brick houses with three full floors. A tall house with a finished attic, a finished basement and a back staircase simply has more to check than its footprint suggests. Every room gets the same attention: windows, outlets, heating, ceilings and floors for signs of movement or water. If you’re quoting, give the total living space, not just the main floors.
Factor 2: Second units and basement apartments
Many older homes near downtown Oshawa and Whitby have been split into a main unit and an apartment, or have a basement suite added later. Each unit means another kitchen, another bathroom, separate exits, smoke and carbon monoxide alarms, and often a second electrical panel or heating system. Yama inspects the condition of each unit. Whether a unit is a legal second unit is a question for the municipality, so ask the seller for any permits and check with the city. See our post on basement apartment inspections.
Factor 3: The foundation and the basement
Older foundations are often stone, rubble or brick rather than poured concrete. They can last a very long time, but they rely on mortar that slowly washes out, and they’re rarely fully waterproof. Yama looks for loose or missing mortar, bulging sections, efflorescence and damp patches, past parging or underpinning, and how the grading and downspouts handle water outside. Low ceilings, old storage and finished walls make this slower, which is why access matters for both price and accuracy. See foundation cracks and basement moisture.
Factor 4: Wiring from more than one era
It’s common to find a modern breaker panel in a century home with some older wiring still in service behind the walls. Yama checks the panel, a sample of outlets and switches on each floor, visible wiring in the basement and attic, and signs of overloaded or amateur connections. Where knob-and-tube is visible, the report notes it and recommends an evaluation by a licensed electrician. Our knob-and-tube vs aluminum wiring guide explains the difference.
Factor 5: Plumbing and the water service
Century homes can still have sections of galvanized steel supply pipe, cast iron drains and, in some cases, an older lead water service line from the street. Yama checks visible supply and drain lines, water pressure and flow at fixtures, and the main shut-off. If the service line looks like lead, the report says so, and you can confirm with the municipality. Older clay or cast iron sewer lines can’t be seen during a visual inspection, so he may suggest a sewer camera inspection by a drain specialist. See galvanized, copper and PEX plumbing.
Factor 6: Heating history and oil tanks
A lot of older homes heated with oil before switching to natural gas. Yama looks for clues of a current or former oil tank, such as fill and vent pipes on the outside wall, cut-off lines in the basement or patched concrete. He also checks the current furnace or boiler, radiators, visible ductwork and venting. If there are signs of an old tank, ask the seller for documentation that it was removed properly. See furnace inspection mistakes.
Factor 7: Additions, attics and outbuildings
Rear kitchens, sunrooms and second-storey additions are very common on century homes. Each one has its own foundation and roof that has to tie into the original house. Yama checks those joints inside and out, the attic over each section for insulation, ventilation and roof leaks, and any detached garage or coach house you want included. See what an attic inspection checks.
A situation we often see
A buyer falls for a renovated century home with a new kitchen, refinished floors and fresh paint. The finishes are lovely, but the inspection is about what’s behind them: an older panel feeding some original circuits, a stone foundation with damp spots behind new drywall, and a rear addition with its own small crawlspace nobody has looked into for years. None of that means walking away. It means knowing which items need a licensed trade, which are maintenance, and which are just normal for a house that age, before you firm up.
Century home inspection checklist for buyers
- Ask the seller about updates to the roof, panel, wiring, plumbing, heating and windows, with dates and permits.
- Ask whether the house ever had an oil tank and whether it was removed.
- Ask if there’s a second unit and whether it was permitted.
- Have the basement walls, attic hatch and crawlspace access cleared before the inspection.
- Look for damp spots, efflorescence or fresh paint low on basement walls.
- Check that outlets in kitchens and bathrooms look updated and that the panel is labelled.
- Ask about older insulation, plaster or textured ceilings before you plan any renovation, and consider home hazard testing.
- Book a conditional or pre-offer home inspection and give the full property details for an accurate quote.
How Yama inspects a century home
Yama works top to bottom, then spends extra time where the old house meets the newer work: the panel and old circuits, the foundation, the joints around additions and the attic over each section. As a contractor, he can tell the difference between wear that’s normal for a 100-year-old house and a sign of an active problem, and he’ll explain which is which in plain language. If something needs a licensed trade or a structural professional, the report says so clearly. Reports reach you within 24 hours. Learn more about our home inspections or read what a home inspection includes in Ontario.
Frequently asked questions
How much does a century home inspection cost in Oshawa, Whitby or Bowmanville?
Home inspections start from $499. The final price depends on the property: size, number of units, access, outbuildings and any hazard testing you add. Call 647-704-7100 or email contact@goldenhomeinspections.ca with the address for a quote.
How long does a century home inspection take?
It usually takes longer than a newer home of the same size, because there are more systems, layers of updates and hard-to-reach spaces to check. Yama will give you an idea of timing when you book.
Does a home inspection test for asbestos or lead?
A home inspection is visual. Yama will point out materials that may contain asbestos and water lines that look like lead, but confirming them takes testing. Hazard testing is quoted separately; see home hazard testing.
Is a century home a bad investment because of its age?
Not on its own. Many century homes are solid and well maintained. The inspection helps you understand the condition of the main systems and what to budget for, so you can make the decision with real information.
Book your inspection: Golden Home Inspections serves Oshawa, Whitby, Bowmanville, Ajax, Pickering, Toronto, Scarborough, Markham, Richmond Hill, Vaughan, Brampton, Mississauga, Oakville and nearby GTA cities. Book an inspection online or call 647-704-7100.
Leave A Comment