Smoke alarms and carbon monoxide (CO) alarms are some of the cheapest safety items in a house, and some of the most overlooked when people buy. Buyers walking through a detached home in Markham, a townhouse in Ajax or a 1950s bungalow in Etobicoke tend to focus on the kitchen, the roof and the basement. The little white disc on the ceiling gets a glance at most. Then, on the first night in the new home, they find out the alarms are 15 years old, the basement has none, or there’s no CO alarm at all even though the house has a gas furnace, a gas fireplace and an attached garage. This guide covers the smoke and CO alarm mistakes we see buyers make most often, and what a home inspection looks at. Your inspector is Yama Nehan, a Certified and Registered Home Inspector with about 15 years of home inspection experience and a construction engineering degree from George Brown (Building Renovations). He is also a licensed contractor with about 20 years of construction experience and the owner of Nehan Construction, and that practical construction experience is one of the main reasons clients pick him. Yama Nehan is the only one trusted to do the inspections himself. Home inspections start from $499 and condo inspections from $399; the final price depends on the property’s size, age and type. Call 647-704-7100 or book an inspection online.
Key takeaways
- The Ontario Fire Code requires working smoke alarms on every storey of a home and outside all sleeping areas.
- CO alarms are required next to sleeping areas in homes with a fuel-burning appliance (such as a gas furnace, water heater or range), a fireplace, or an attached garage.
- Alarms don’t last forever. Most manufacturers say to replace smoke alarms after about 10 years, and CO alarms often after 7 to 10 years. Check the date on the back.
- Finished basements, basement apartments and condo units are where missing or misplaced alarms show up most.
- A home inspection notes alarm presence, placement and visible age, and flags related CO risks like venting and garage doors. It is not a gas appliance service.
Smoke alarm vs CO alarm vs combination alarm
| Item | Smoke alarm | CO alarm | Combination smoke/CO alarm |
|---|---|---|---|
| What it detects | Smoke from a fire | Carbon monoxide, a gas you can’t see or smell | Both, in one unit |
| Where Ontario requires it | Every storey and outside all sleeping areas | Next to each sleeping area, where there’s a fuel-burning appliance, fireplace or attached garage | Can serve both roles if installed in a spot that suits both |
| Typical replacement | About 10 years (check the manufacturer) | Often 7 to 10 years (check the manufacturer) | Follows the shorter life of the two sensors |
| Common power types | Battery, or hardwired with battery backup in newer homes | Plug-in, battery or hardwired | Battery or hardwired |
| What buyers usually miss | Expired units, none in the basement | None at all, or only one in the basement | Assuming one combo unit covers the whole house |
7 smoke and CO alarm mistakes buyers make
1. Assuming the seller’s alarms work and are in date
A working test button doesn’t mean an alarm is current. Most alarms have a manufacture or “replace by” date printed on the back or side. In homes that haven’t changed hands in a long time, it’s common to find alarms that are well past their replacement date, or a mix of new and old units. In older Etobicoke and Scarborough bungalows, we also see original battery units on the main floor with nothing on the lower level. Plan on replacing any alarm that’s expired, unlabelled or yellowed with age when you move in.
2. Forgetting the CO alarm when there’s an attached garage or gas fireplace
Many Markham, Ajax and Pickering subdivision homes have an attached garage, a gas furnace, a gas water heater and often a gas fireplace. Any one of those is enough to trigger Ontario’s CO alarm requirement next to sleeping areas. Buyers sometimes assume a CO alarm is only needed for older furnaces. It isn’t: a car started in the garage or a blocked vent on a newer appliance can produce CO too. See our guide to the attached garage inspection for the garage side of this.
3. Putting the CO alarm only in the basement
The furnace room feels like the obvious spot, and a CO alarm there isn’t a bad idea. But the requirement is about sleeping areas: the alarm has to be where it will wake people up. A single CO alarm beside a basement furnace, two floors below the bedrooms, may never be heard at night. Check the hallway outside the bedrooms on the upper floor.
4. Finishing the basement and skipping the alarms
A finished basement is a storey, so it needs a smoke alarm, and a basement bedroom brings in the “outside sleeping areas” rule too. When a basement is finished after closing, especially without a permit, alarms are often the first thing left out. If you’re looking at a home in Brampton, Mississauga or Ajax with a basement bedroom or rec room, look for an alarm on that level and ask the seller whether the basement was permitted. Our finished basement red flags guide covers what else to watch for.
5. Treating a basement apartment like a single-family home
Two-unit houses have extra fire-safety requirements in Ontario, and smoke alarm interconnection between the units is a common one. A side-door basement unit with its own battery alarm, not linked to the main house, is something we flag often. If you’re buying a house with a second unit in Brampton, Mississauga or Oshawa, confirm its status with the city and ask what fire-safety work was done. Our basement apartment inspection guide goes deeper.
6. Assuming the condo corporation handles it
Condo buildings in Toronto, Mississauga and Markham have a building fire alarm system, and that’s the corporation’s job. The smoke alarm inside your suite is a separate device, and in Ontario the unit owner is generally responsible for keeping it working. If the suite has a gas range or fireplace, or sits next to a service room or garage with fuel-burning equipment, CO alarm rules can apply too. Ask the condo corporation how they handle in-suite alarms, and check them during your condo inspection.
7. Thinking the alarm check covers the gas appliances
An alarm warns you about CO; it doesn’t tell you why it’s there. During a home inspection, Yama looks at the visible parts of the CO picture: furnace and water heater venting, rusted or disconnected vent pipes, signs of backdrafting, the condition of the door between the garage and the house, and the dryer vent. What a home inspection doesn’t do is a combustion test or service of gas appliances. If anything looks off, the next step is a TSSA-registered gas technician. See our furnace inspection mistakes guide for more.
What a home inspection checks for alarms and CO risk
- Smoke alarm present on every storey, including the basement
- Smoke alarm outside each sleeping area (and inside bedrooms where the home was built that way)
- CO alarm next to sleeping areas when there’s a gas appliance, fireplace or attached garage
- Visible date codes, missing covers, painted-over or disconnected units
- Furnace, boiler and water heater vent connections and visible corrosion
- Gas fireplace venting and visible clearances
- Door between the attached garage and the house: weatherstripping, fit and closing
- Dryer vent material, length and exterior termination
- Basement apartments: whether alarms in each unit appear to be linked
Buyer checklist for move-in day
- Write down the date on every alarm and replace any that are expired or unlabelled
- Add a CO alarm outside the bedrooms if the home has gas, a fireplace or an attached garage
- Put a smoke alarm on every level, including a finished or unfinished basement
- Test every alarm and replace batteries in battery units
- Book a gas appliance service if the furnace or water heater has no recent service record
- For a condo, ask management how in-suite alarms are checked
A situation we often see
A family buys a two-storey home with an attached garage and a gas fireplace. On a showing, the house looks well kept: there’s a smoke alarm in the upstairs hallway and one on the main floor. At the home inspection, the details come out: both alarms are past the date printed on the back, the basement has been finished into a rec room and office with no alarm on that level, and the only CO alarm is plugged in next to the furnace. The door from the garage into the laundry room doesn’t close fully and the weatherstripping is worn. None of it is expensive, but all of it matters for the first night in the house, and it’s much easier to sort out before move-in than after.
Why buyers pick Golden Home Inspections
Yama Nehan has about 15 years of home inspection experience. As a licensed contractor with about 20 years of construction experience and the owner of Nehan Construction, he knows how GTA homes are built and how basements, garages and second units are usually added on later. That practical construction experience is one of the main reasons clients pick him. Yama Nehan is the only one trusted to do the inspections himself, and reports reach clients within 24 hours. Learn more about our home inspections, or see the pages for home inspection in Markham, home inspector in Ajax and home inspector in Etobicoke. If you also want testing for radon, mould or asbestos, see our home hazard testing page.
FAQ
Does a home inspector test smoke and CO alarms?
A home inspection notes whether alarms are present, where they are, and their visible condition and age, and may use the test button where it’s safe and reachable. It isn’t a certification of the alarm system. Test and replace alarms yourself when you move in.
Where do CO alarms need to go in an Ontario home?
Next to each sleeping area, in homes with a fuel-burning appliance, a fireplace or an attached garage. Follow the manufacturer’s instructions for exact mounting height and location.
How often should smoke alarms be replaced?
Most manufacturers say about every 10 years. CO alarms are often 7 to 10 years. The date is usually printed on the back of the unit.
Is the seller required to leave working alarms?
Under the Ontario Fire Code, the homeowner is responsible for keeping smoke and CO alarms working. Ask your real estate lawyer how that’s handled in your agreement, and check the alarms yourself on closing day.
Which areas do you cover?
Golden Home Inspections serves Markham, Ajax, Etobicoke, Toronto, Mississauga, Brampton, Oakville, Vaughan, Richmond Hill, Pickering, Whitby, Oshawa and nearby GTA cities.
Book your home inspection: Golden Home Inspections serves Markham, Ajax, Etobicoke, Toronto, Mississauga, Brampton, Oakville, Vaughan, Richmond Hill, Pickering, Whitby, Oshawa and nearby GTA cities. Book an inspection online or call 647-704-7100.
Leave A Comment